VeSync Vital 200S
Smart Air Purifier
Device type
Air Purifier
Max power
2.91 W
Standby power
0.25 W
Through the interface (recommended)
Start the Powercalc config flow, choose Virtual power (library), and pick VeSync → Vital 200S.
Add this to your configuration.yaml, replacing light.my_light with your own entity.
powercalc:
sensors:
- entity_id: light.my_light
manufacturer: vesync
model: Vital 200SDevice
- Manufacturer
- VeSync
- Aliases
- LAP-V201S-WUS+5 more
- Form factor
- Air Purifier
- Connectivity
- Wi-Fi
- Product page
- levoit.com
Power
- Power range
- 0.25 – 2.91 W
- Rated power
- 51 W claimed
Measurement
- Calculation strategy
- Fixed
- Measure device
- Sonoff S31
- Measure method
- Manual
- Measure description
- Vital 200S-P, US 120 V, measured at the wall with a Tasmota Sonoff S31; three minute averages per state. Display draws 0.6 W and is subtracted when display_status is off. Manual speeds and sleep are measured directly. Auto maps the air_quality sensor state (excellent/good/moderate/poor, the manual's Very Good/Good/Moderate/Bad) to sleep/low/medium/high speed per the manual; only excellent was measured (PM2.5 1). Pet alternates 15 min high and 60 min medium per the manual (cycle not measured); value is the cycle average. Both presets assume light detection is off or the room is lit. With light detection on, the unit caps them at medium (50 %) in the dark, a state HA cannot see. Standby is below the S31's floor and comes from corrected Shelly Plug history.
- Mains voltage
- 120 V
Library
- Created
- Sep 3, 2026, 12:00 AM UTC
- Updated
- Authors
- Min version
- v1.25.3
- Discovery
- Automatic, by entity