Skip to main content
Powercalc Profile Library
Github

Shelly S3PL-00112EU

Plug S Gen3

Device type
Smart Switch
Max power
1.1 W
Standby power
0.82 W
Sub profiles
8
Device's own consumption only; excludes connected appliances.

View discovery and setup instructions for this profile.

Community usage
241 opted-in installations
3.33% of 7,233 reporting installationsOpt in to analytics

Device


Manufacturer
Shelly
Description
Smart Wi-Fi Plug with Power Monitoring & Matter
Aliases
Shelly Plug S MTR Gen3
Form factor
Plug
Connectivity
Wi-Fi, Bluetooth, Matter, Knx
Barcode
3800235261842
Product page
shelly.com
Power monitoring
Yes

Power


Power range
0.23 – 1.1 W
Rated power
1 W claimed

Measurement


Calculation strategy
Fixed
Measure device
Shelly Plug S Gen3
Measure method
Manual
Measure description
Setup: the tested plug and a calibrated resistive dummy load are connected in parallel to the same mains input, and a second Shelly Plug S Gen3 measures upstream of both. The dummy load is never connected to the relay output, so the reference meter always reads about 33 W and can resolve the sub-watt self-consumption of the plug. The plug stays powered in both relay states; only the output relay changes, so the meter always sees the plug plus the dummy load. The dummy load was calibrated with the measurement tool at 1600.01 Ohm, i.e. about 33 W at 230 V. Its contribution is subtracted from every sample instead of being applied as a fixed offset, because it follows the mains voltage: P_self = P_upstream - (V^2 / R) The tool applies this per sample and averages over the measurement window for each state. Two plateaus from the reference meter log during the run, one with the relay off and one with it on: - Relay OFF: V = 229.9 V, P_upstream = 33.70 W, V^2/R = 33.03 W, resulting P_self = 0.67 W. - Relay ON (no load at the output): V = 230.0 V, P_upstream = 34.10 W, V^2/R = 33.06 W, resulting P_self = 1.04 W. The stored sub-profile values are the averages of these per-sample subtractions over the whole window, so a single plateau can differ from the stored value by a few tenths of a watt. For sub-profiles with LED enabled, the LED was active at full brightness only while the relay was switched on. Firmware version 2.1.1.
Mains voltage
230 V
Measure settings
DUMMY_LOAD: trueDUMMY_LOAD_POWER: 33DUMMY_LOAD_RESISTANCE: 1600.01VERSION: v0.14.1:app

Library


Created
Nov 1, 2026, 9:30 PM UTC
Updated
Contributors
Discovery
Automatic, by entity
Only self usage
Yes